Project Details
Description
The project examines the possibilities within 3d printing with porcelain in relation to glaze and ornamentation. In addition, assembling of several 3d printed modules by the use of ceramic glaze and firing are examined.
The design is based on the use of Rhino / Grasshopper software. Here, several sinus curves form the basis for a profile that is subdivided into facets.
The design is based on the use of Rhino / Grasshopper software. Here, several sinus curves form the basis for a profile that is subdivided into facets.
| Status | Finished |
|---|---|
| Effective start/end date | 01/02/2018 → 01/09/2019 |
Keywords
- ceramics
- 3d printing
- 3d digital form
- programming
- grasshopper
- ornamentation
- glaze
Research output
- 1 Article in proceedings
-
Practitioners’ Experience in Clay 3D Printing: Metaphorical viewing for gaining embodied understanding
Falin, P., Horsanali, N., Hansen, F. T. & Mäkelä, M., 10 May 2021, Proceedings of BICCS 2021: Biennial International Conference for the Craft Sciences. Special Issue . 2 ed. Vol. 14. 15 p.Publications: Chapter in Book/Report/Conference proceeding › Article in proceedings › Research › peer-review
Open Access